Daily Archives: December 6, 2010

Stop the Noise!

Your garage door is made up of an intricate system of pulleys, cables, gears, and springs, so there are various components that may trigger the door to make noise. A few of these are simply fixed, and a few require the service of a skilled garage door technician.

First, it is advisable to establish the type of garage door opener you own: screw drive, chain drive, or belt drive. Chain drive doors are noisy. This doesn’t make them a foul choice. Chain drive doorways are comparatively inexpensive, long-lasting, and reliable in extreme climates. Common lubrication will lessen the noise, but it surely is not going to go away. Screw drive doorways are much less noisy early on; however they become just as noisy as chain drive doors over time. A belt drive door is quiet when it’s working properly.

If the garage door is just not balanced, it may become noisy, or it can even stop operating. You may examine the stability of the door by pulling the red emergency launch cord and working the door manually. Raise the door manually about halfway, and then release it. If it is correctly balanced, it will have little movement. Whether it is unbalanced, it will begin to fall. Sometimes, worn springs are the problem. Extension springs, which run alongside the sides of the door. Can easily be replaced by the homeowner. Torsion springs, which run along the highest of the door, need to be dealt with care. You most likely need to name an expert garage door repair service.

A simple drawback to fix is a hinge. If the noise you hear is a squeak, oiling the hinges could be the solution.

Do you hear a grinding noise? This might imply a bent gear and sprocket and they should be replaced. The gear and sprocket are situated inside the primary console. Except you know quite a bit about equipment, you will most likely have to name a professional garage door repair service. If you opt to do the job yourself, be sure you unplug the unit!

When you hear a ticking sound, the issue might be worn bearings, either in the pulley or the rollers. You want to change the bearings. Be sure you understand how to do that as you could be severely injured.

Another common problem is that the springs have become bent and are rubbing in opposition to each other. If that is the problem, you will hear a grating noise. The spring should be replaced. Refer to the third paragraph regarding torsion springs and extension springs.

If you decide to do the work on the garage door yourself, be extraordinarily careful. A garage door is a heavy piece of apparatus that can cause damage to folks and property if it is not handled with knowledge and caution.

Leave a comment

Filed under garage door